2
Specifications are
subject to change
without notice
WARNING!
READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS AND
WARNINGS BEFORE OPERATING THIS TOOL. FAILURE TO DO
SO MAY RESULT IN PERSONAL INJURY AND/OR PROPERTY
DAMAGE AND WILL VOID WARRANTY.
1. Keep work area clean. Cluttered areas invite injuries.
2. Observe work area conditions. Do not use machines or power tools in damp
or wet locations. Don’t expose to rain. Keep work area well lighted. Do not
use electrically powered tools in the presence of ammable gases or liquids.
Do not bring combustible materials near the tools.
3. Keep children away. Children must never be allowed in the work area. Do not
let them handle machines, tools, hoses or extension cords.
4. Store idle equipment. When not in use, tools must be stored in a dry location
to inhibit rust. Always lock up tools and keep out of reach of children and other
untrained persons. Switch off all unused electrical tools when stored. Tools
are dangerous in the hands of untrained users.
5. Always wear approved eye protection when using tools. If raising dust, wear a
suitable mask.
6. Work Safe. Do not wear loose clothing or jewelry that could become caught
by moving parts, causing injury. Operate tool a safe distance from yourself
and others in the work area. Keep proper footing and balance at all times. Do
not reach over or across running machines, hoses, etc.
7. Do not operate any tool if under the inuence of alcohol or drugs. Read
Square Drive (IN.) ............................ 3/8
Working Torque (FT. /LBS) ..........20-75
Air Pressure (PSI) ............................. 90
Average Air Consumption (CFM) ...... 3
Free Speed (RPM) ........................11000
Bolt Capacity (IN.) ............................ 3/8
Air Inlet (NPT) ..............................1/4 in.
Hose Size (ID)..............................3/8 in.
Weight (LBS) .................................... 2.0
Warning!
Oil tool before each use. 4 to 5 drops of a good grade Air Tool Oil
placed in the air inlet is sufficient. Use proper air pressure and CFM
rating listed for this tool.
SPECIFICATIONS
IMPORTANT SAFETY INFORMATION
To Next Page
Loading...
Need help?
General
