Warning!
Oil tool before each use. 4 to 5 drops of a good grade Air Tool
Oil placed in the air inlet is sufficient. Use proper air pressure
and CFM rating listed for this tool.
Drain water from hoses and compressor tank. Water in the air supply line
will cause gumming and loss of power. Clean the air lter on the supply
line and ush the tool with gum solvent or a 50/50 mix of air tool oil and
kerosene. It may be necessary to disassemble the tool to properly clean
and re-lubricate.
INSUFFICIENT POWER:
Probable Cause Solution
Dirty or clogged air passages Flush and lubricate tool, drain air tank
and supply line
Insufficient air supply Increase line pressure, make sure
compressor matches tool's air pressure
and consumption needs
Air leakage Use PTFE tape at all fittings and joints.
Check tool for worn or damaged O-rings
& seals.
Worn/damaged wear &
tear parts Replace as necessary.
Tool matching Be sure you are using a tool suited for
the requirements of the job at hand.
TROUBLESHOOTING
LUBRICATION & MAINTENANCE
To Next Page
Loading...
Need help?
General
