3
warning labels on prescriptions to determine if your judgment or reexes are
impaired while taking drugs. If there is any doubt, do not operate any tool.
8. Be sure air is in OFF position when connecting tool to air supply.
9. Use only those accessories that are designed for use with tools. For example,
with impact wrenches do not use ordinary sockets. Use impact sockets for all
air tools.
10. Be sure to disconnect tool from air supply before changing accessories,
performing service on tool and when not in use.
11. Follow air source manufacturers' directions for connection of regulators,
lters, and other accessories to air source. Do not install quick couplers
directly on tool as they put unnecessary strain on the air inlet threads possibly
causing them to wear out prematurely. Instead, install them on a short length
of air hose attached to the tool.
12. Check for damaged parts. Before using any tool, any part that appears dam-
aged should be carefully checked to determine that it will operate properly
and perform its intended function. Check for alignment and binding of moving
parts; any broken parts or mounting xtures; and any other condition that may
affect proper operation. Any part that is damaged should be properly repaired
or replaced by a qualied technician.
13. Maintenance. For your safety, maintenance should be performed regularly
by a qualied technician using original PERFORMANCE TOOLS® replace-
ment parts. Failure to do so can lead to accidents for the operator. Use of any
other parts will void the warranty. Only use accessories intended for use with
this tool. Approved accessories are available from Performance Tool®. Use
only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool may become hazardous when
used on another tool.
WARNING: This product and its packaging contain a chemical known to the
State of California to cause cancer, birth defects, or other reproductive harm.
WARNING: The warnings, cautions, and instructions discussed in this instruc-
tion manual cannot cover all possible conditions and situations that may occur. It
must be understood by the operator that common sense and caution are factors
which cannot be built into this product, but must be supplied by the operator.
Read and understand all of the instructions provided in the instruction manual of
this product, as well as, any other tool (s) used with this product.
IMPORTANT SAFETY INFORMATION
To Next Page
Loading...
Need help?
General
