2
Overall Length: ...........................................................................................6.7 in.
Material: ...........................................................................................Carbon Steel
Handle Type: ...............................................................................Sliding T-Handle
Adapter Plates: .........................................................................................14 pcs.
Wind Back Tool: .........................................................................................2 pcs.
Disc Pad Spreader: ......................................................................................1 pc.
SPECIFICATIONS:
Specifications are subject to change without notice.
This instruction manual is intended for your benefit. Please read and follow the safety, installation, maintenance and troubleshooting
steps described within to ensure your safety and satisfaction. The contents of this instruction manual are based upon the latest
product information available at the time of publication. The manufacturer reserves the right to make product changes at any time
without notice.
SAFETY GUIDELINES / DEFINITIONS
WARNING: Read and understand this entire instruction manual before attempting to assemble, install, operate or maintain
this product. Failure to comply with the instructions may result in serious personal injury and/or property damage!
The following signal words are used to emphasize safety warnings that must be followed when using this product:
DANGER:
Indicates an imminently hazardous situation
that, if not avoided, WILL result in death or serious injury.
WARNING:
Indicates a potentially hazardous situation that,
if not avoided, COULD result in death or serious injury.
CAUTION:
Indicates a potentially hazardous situation that,
if not avoided, MAY result in minor or moderate injury.
NOTE: Indicates important information, which if not
followed, MAY cause damage to equipment.
TOOL FEATURES
1
5. Pins
6. Disc Pad Spreader
7. Wind Back Tool
8. Adapter Plates
1. Handle
2. Bolt
3. Tightening Screw Cap
4. Adapter
2
3
4
6
7
8
5
To Next Page
Loading...
Need help?
General
