WARNING: Know your detail saw. Do
not plug in the detail saw until you have read
and understand this Instruction Manual.
Learn the tool’s applications and limitations,
as well as the specific potential hazards
related to this tool. Following this rule will
reduce the risk of electric shock, fire, or serious
injury.
Always wear eye protection. Any
power tool can throw foreign
objects into your eyes and cause
permanent eye damage. ALWAYS
wear safety goggles (not glasses) that comply
with ANSI safety standard Z87.1. Everyday
glasses have only impact resistant lenses. They
ARE NOT safety glasses.
WARNING: Glasses or goggles not in
compliance with ANSI Z87.1 could cause
serious injury when they break.
Always wear safety goggles, hearing protection
and a dust mask. Use only in well-ventilated
areas. Using personal safety devices and
working in a safe environment reduces the risk
of injury.
WARNING: Never cut metals such as
steel, copper or brass. These materials are too
hard and will break the blade and possible
cause injury to the operator.
WARNING: Never attempt to plunge cut
with this tool. The fine blades will likely break
and possibly cause injury to the operator.
Hold the tool by insulated gripping surfaces
when performing an operation where the saw
blade may contact hidden wiring or its own cord.
Contact with a “live” wire will make exposed
metal parts of the tool “live” and shock the
operator.
Always make sure the work surface is free of
nails and other foreign objects. Cutting into a
nail can cause the blade and the tool to jump
and damage the blade.
Never hold the workpiece in one hand and the
tool in the other hand when sawing.
Never place your hands near or below the
cutting surface. Clamping the material and
guiding the tool with both hands is much safer.
Never lay the workpiece on hard surfaces like
concrete, stone, etc. The protruding blade may
cause the tool to jump.
DANGER: Always remove the plug from
the power supply when changing the blade and
when making adjustments.
Use only mini detail saw blades that are
designed specifically for mini or compact detail
saw use. Never use a broken blade, as it will not
be securely held in the tool.
After changing a blade, make sure the blade is
securely held in the blade holder. Loose blades
will be violently thrown.
Never touch the blade during or immediately
after use. After use, the blade is too hot to be
touched by bare hands.
Never use dull or damaged blades. Sharp
blades must be handled with care. Damaged
blades can snap during use. Dull blades require
more force to cut the workpiece, possibly
causing the blade to break.
SAVE THESE INSTRUCTIONS FOR REFERENCE
To Next Page
Loading...
Need help?
General