Performax 241-0995 User Manual

13
INSTALLING THE EDGE GUIDE – cont’d
MATERIALS YOU CAN CUT
This detail saw is a versatile tool that allows you
to cut many different types of materials. Some of
these materials include:
 Wood products such as plywood,
composite board, laminate and panelling
 Drywall
 Styrofoam
 Fibre board and plastic
GENERAL CUTTING
1. Clearly mark the workpiece to locate the
position of the cut.
2. Hold smaller workpieces with a vise. Clamp
larger workpieces to a workbench or table.
DANGER: Any workpiece that is not
adequately clamped in place may come
loose and cause serious injury. Never hold
the workpiece with your hand.
WARNING: Keep your hands and
fingers away from between the motor
housing and the blade holder. Do not reach
underneath the workpiece while the detail
saw is running.
3. Set the speed control wheel to the desired
speed. Use slower speeds for cutting
plastics and higher speeds for cutting wood
and laminates.
ASSEMBLY AND OPERATING ASSEMBLY AND OPERATING
!
!
Fig. 7
1
2
3
4
For safety reasons, the operator must
read the sections of this Owner’s Manual
entitled "GENERAL SAFETY
WARNINGS", "POWER TOOL SAFETY",
"SPECIFIC SAFETY RULES",
"GUIDELINES FOR EXTENSION CORDS"
and "SYMBOLS" before using this detail
saw.
Verify the following every time the detail
saw is used:
1. The blade is sharp and in good
condition.
2. The blade is firmly clamped into the
blade holder.
3. The workpiece is properly secured.
4. Safety glasses, hearing and
breathing protection are being worn.
Failure to observe these safety rules will
significantly increase the risk of injury.
WARNING
!

Performax 241-0995 Specifications

General

Brand	Performax
Model	241-0995
Category	Saw
Language	English