Need help?Do you have a question about the PerkinElmer AVIO 200 and is the answer not in the manual?
General| Type | Inductively Coupled Plasma Optical Emission Spectrometer (ICP-OES) |
|---|---|
| Wavelength Range | 165 – 900 nm |
| Spray Chamber | Cyclonic spray chamber |
| Optical System | Echelle optical system |
| Detector | Solid-state detector |
| Plasma View | Axial and radial view |
| RF Power | 750 – 1500 W |
| Nebulizer | SeaSpray nebulizer |
| Gas Flow Control | Mass flow controller for plasma, auxiliary, and nebulizer gas |
| Interface | Ethernet |
| Memory Effect | Minimized |
| Operating Environment | Temperature: 15 to 30 °C; Humidity: 20 to 80% RH |
| Power Requirements | 200 – 240 VAC, 50/60 Hz |
| Detection Limits | μg/L levels, element dependent |
Addresses safety interlocks, RF/UV radiation, electrical hazards, and high temperatures.
Provides guidance on safe handling of gas cylinders, chemicals, and waste disposal.
Specifies exhaust vent requirements and gas supply needs (Argon, Purge, Shear).
Details connecting gas supplies, cooling water, and the PolyScience chiller system.
Guides the installation of the torch module, spray chambers, and autosampler.
Covers setting torch position, instrument parameters, and switching on the system.
Details maintenance for torch, plasma plates, nebulizer, spray chamber, and peristaltic pump.
Details performance tests and troubleshooting for sample introduction system problems.
Addresses issues related to plasma ignition failures and plasma instability.
To Next Page