Need help?Do you have a question about the PerkinElmer Lambda 650 and is the answer not in the manual?
General| Photometric Accuracy | ±0.002 A |
|---|---|
| Baseline Flatness | ±0.0005 A |
| Light Source | Deuterium |
| Detector Type | Photomultiplier Tube (PMT) |
| Sample Compartment | Standard 10 mm cell holder |
| Power Requirements | 100-240 V, 50/60 Hz |
Defines text conventions, keyboard input, and terminology used in the manual.
Explains the use of NOTE, CAUTION, and WARNING for special circumstances and alerts.
Lists essential safety precautions and general operating conditions for using the spectrometer.
Details ambient conditions, electrical hazards, grounding, and safety practices for operation.
Illustrates warning labels and explains fuse replacement procedures for safety.
Introduces the Lambda spectrometers, their spectral ranges, and key features.
Describes the all-reflecting, double-monochromator optical system and its components.
Outlines differences for Lambda 1050, Sphere-only, and Detector-less systems.
Lists site requirements and provides instructions for safely unpacking the spectrometer.
Details connecting the spectrometer to power and establishing PC communication.
Guides users through installing UV WinLab software and calibrating the instrument.
Covers installing accessories and removing key components like the detector unit.
Outlines the steps for powering on and initializing the spectrometer and accessories.
Describes the single-cell holder and guides its installation and alignment.
Discusses microcell use and the procedure for purging the instrument with inert gas.
Lists daily checks, cleaning procedures for covers and sample compartment.
Provides guidelines for cell care and lists available replacement parts.
Details the procedures for replacing halogen and deuterium lamps.
Provides instructions for the disposal of electrical and electronic equipment according to WEEE directive.
Outlines procedures for decontaminating and cleaning instruments before return or repair.
To Next Page
