Need help?Do you have a question about the PerkinElmer Lambda 365 and is the answer not in the manual?
General| Wavelength Range | 190 - 1100 nm |
|---|---|
| Power Requirements | 100-240 V AC, 50/60 Hz |
| Wavelength Accuracy | ±0.3 nm |
| Wavelength Repeatability | ±0.1 nm |
| Wavelength Reproducibility | ±0.1 nm |
| Photometric Repeatability | ±0.001 Abs |
| Baseline Flatness | ±0.0005 Abs |
| Baseline Stability | <0.0003 Abs/hour (after warm-up) |
| Data Interval | 0.1 - 5 nm |
| Light Source | Tungsten halogen lamp and deuterium lamp |
| Sample Compartment | Standard 10 mm cell holder |
| Detector | Silicon Photodiode |
Lists essential precautions to be observed when using the Lambda 365 instrument.
Details the environmental and operational conditions for safe use of the Lambda 365.
Outlines recommended electrical safety practices to prevent hazards.
Provides step-by-step instructions for installing the Lambda 365 instrument.
Details the process of installing the UV Express software on a computer.
Guides through connecting and setting up the USB interface between the computer and instrument.
Explains how to configure USB serial ports for instrument communication.
Details the step-by-step procedure for operating the Lambda 365 instrument.
Details the accessory for precise temperature control of single cells.
Describes the accessory for temperature control of multiple cells.
Provides instructions for safely replacing the D2 lamp.
Details the procedure for replacing the Tungsten lamp module.
To Next Page
