PerkinElmer Lambda 365 User Manual

Safety Practices . 25
EMC Compliance
EC directive
The Lambda 365 has been designed and tested to meet the requirements of the EC directive
2006/95/EC. The Lambda 365 complies with the EMC standard EN61326-1, (EMC standard
for electrical equipment for measurement, control and laboratory use) and EN61000-3.
FCC rules and regulations
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications, However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
● Consult the dealer or an experienced radio/TV technician for help.
Installation Category
This product will operate safely in electrical power environments that are rated as Installation
Category II in EN/IEC 61010-1.
Pollution Degree
This product will operate safely in environments that contain nonconductive foreign matter
up to Pollution Degree 2 in EN/IEC 61010-1.

PerkinElmer Lambda 365 Specifications

General

Wavelength Range	190 - 1100 nm
Power Requirements	100-240 V AC, 50/60 Hz
Wavelength Accuracy	±0.3 nm
Wavelength Repeatability	±0.1 nm
Wavelength Reproducibility	±0.1 nm
Photometric Repeatability	±0.001 Abs
Baseline Flatness	±0.0005 Abs
Baseline Stability	<0.0003 Abs/hour (after warm-up)
Data Interval	0.1 - 5 nm
Light Source	Tungsten halogen lamp and deuterium lamp
Sample Compartment	Standard 10 mm cell holder
Detector	Silicon Photodiode