Need help?Do you have a question about the PerkinElmer aanalyst 200 and is the answer not in the manual?
General| Type | Atomic Absorption Spectrometer |
|---|---|
| Category | Laboratory Equipment |
| Wavelength Range | 190 - 900 nm |
| Flame Type | Air-Acetylene, Nitrous Oxide-Acetylene |
| Detector Type | Photomultiplier Tube |
| Detection Limit | Varies depending on element |
| Light Source | Hollow Cathode Lamp |
| Spectral Bandwidth | 0.2, 0.7 nm |
| Optical System | Double-beam |
| Display | LCD |
| Connectivity | RS-232 |
Details on document release history, notices, copyright information, and trademarks.
Overview of the AAnalyst 200 User's Guide, including chapter summaries.
Explains text conventions, notes, cautions, and warnings used throughout the manual.
Describes general safety practices and precautions for operating the AAnalyst 200.
Covers built-in safety features, interlocks, and correct instrument usage.
Lists essential precautions for using the AAnalyst 200 safely.
Details hazards associated with flame atomization: high temperatures, toxic products, and UV radiation.
Introduction to laboratory setup requirements for the AAnalyst 200.
Specifies required environmental conditions for the AAnalyst 200's laboratory.
Covers operating, safe operating, and storage conditions for the laboratory.
Details laboratory hygiene standards and safe chemical handling procedures.
Introduction to the AAnalyst 200 instrument and its versions.
Provides a general overview of the AAnalyst 200 instrument.
Describes the system concept, components, and control mechanisms.
Information on different types of lamps used with the AAnalyst 200.
Guidance on preparing for and performing the AAnalyst 200 installation.
Instructions for inspecting the shipment and unpacking the spectrometer.
Procedure for safely placing the spectrometer onto a laboratory bench.
Steps for installing the touch screen accessory onto the instrument.
Procedure for starting up the AAnalyst 200 system and setting burner gas pressures.
Summary of procedures for setting up the burner system.
Details on installing the nebulizer and other components onto the burner mount.
Step-by-step guide for safely igniting the flame in the burner.
Describes the touch screen interface and its components like pages, dialogs, and tabs.
Details parameters on the Lamp page: Signal, Element, Wavelength, Slit.
Describes parameters on the Flame page: Oxidant, Oxidant Flow, Acetylene Flow.
Covers Spectrometer and Calibration subpages for setting analytical parameters.
Introduction to routine maintenance procedures and checks for the instrument.
Checklist for general maintenance, including work area cleanliness and spill cleanup.
Checklist for preventative maintenance of the spectrometer, including surfaces and optics.
Checklist for maintaining the burner system, head, nebulizer, and gas hoses.
Introduction to troubleshooting, error diagnosis, and contacting customer service.
Addresses common problems in flame analyses like high/low results and characteristic concentration.
Troubleshoots issues related to flame ignition and burner flashbacks.
Diagnoses common problems with lamps not fitting, not lighting, or having low energy.
To Next Page