• Check the condition of the gauges. Replace any
gauges that are cracked. Replace any gauge that
cannot be calibrated.
i03570653
Water Pump - Inspect
A failed water pump may cause severe engine
overheating problems that could result in the
following conditions:
• Cracks in the cylinder head
• A piston seizure
• Other potential damage to the engine
Illustration 90 g01904773
(A) Weep hole
(B) Vent hole
Note: The water pump seals are lubricated by the
coolant in the cooling system. It is normal for a small
amount of leakage to occur. Refer to illustration 90
for the position of the weep hole and the vent hole.
Visually inspect the water pump for leaks.
Note: If engine coolant enters the engine lubricating
system the lubricating oil and the engine oil filter must
be replaced. This will remove any contamination that
is caused by the coolant and this will prevent any
irregular oil samples.
The water pump is not a serviceable item. In order to
install a new water pump, refer to the Disassembly
and Assembly Manual, “Water Pump - Remove and
Install”.
SEBU8601-04
129
Maintenance Section
Water Pump - Inspect
To Next Page
Loading...
