““Shutdown””
The orange warning will be “Flashing” . After the
warning, the engine power will be derated. The
engine will continue at the rpm of the set derate until
a shutdown of the engine occurs. After shutdown the
red stop lamp will illuminate.
A shutdown of the engine after being triggered is
immediate. The engine can be restarted after a
shutdown for use in an emergency. However, the
cause of the initial shutdown may still exist.
If there is a signal for high coolant temperature, there
will be a 2 second delay to verify the condition.
If there is a signal for low oil pressure, there will be a
2 second delay to verify the condition.
For more information or assistance for repairs,
consult your Perkins distributor.
i07426635
Monitoring System
(Engine Warning Indicators)
Table 3
Table for Warning Indicators
Warning Indicator
Shutdown
Indicator Indicator State
Description of the
Indication
Engine Status Operator Action
ON ON Indicator Check Keyswitch in the ON posi-
tion all Indicators should il-
luminate for 0.5 of a
second.
Power ON, Indicator
check
Engine is not
operating.
If any of the Indicators will
not illuminate during the
Indicator check, the fault
must be investigated
immediately.
If any Indicator stays illu-
minated or flash, the fault
must be investigated
immediately.
OFF OFF No Fault
-
Engine operating
normally.
None
Level 1
ON (Solid) OFF Level 1 An active diagnostic code
is present.
The engine is operat-
ing, but one or more
diagnostic codes are
present.
As soon as possible the
diagnostic code should be
investigated.
Level 2
Flashing OFF Level 2 The ECM has detected an
abnormal condition.
If enabled, the engine
will be derated.
Stop the engine.
Investigate the fault.
(continued)
42 M0094137-02
Operation Section
Monitoring System
To Next Page
Loading...
