Perlesmith PSTVS04 - Step 1: Assemble the Base; Attach Foot Pads to Base; Connect Support Pillar to Base

P5
Place foot pads [W] to the frosted side of the tempered glass
base [O] in the corners
Step 1-1
Connect the support pillar [P] to tempered glass base [O]
Step 1-2
Note: Make sure the
side with the wire clip
holes on the support
pillar faces the back
of the stand
Note: The paper
side of the gasket
with 3 holes [R]
should be touched
the tempered glass
base [O]
Attach the top cover [Z] to the support pillar [P]
Secure the support pillar [P] to tempered glass base [O] using plastic cover
[Y], gasket with 3 holes [R], bolts [L] and Allen key [V]
(K1) x2
Safety Lock
Note: You may need
assistance with this step.
Supplied Part and Hardware for Step 5
Step 1 Assemble the Base
O
W
R
O
Y
P
Z
L
V
O
V
L
R
Table
P
Front Side
Back Side