Perma Distributor PRO MP-6 - perma PRO PRO LC Replacement

perma PRO 
6. Replacement of the PRO LC
The Following Must Always Be Taken into Account
,IWKHUHSODFHPHQWRIDQHPSW\352/&EHFRPHVQHFHVVDU\LWZLOOEHLQGLFDWHGE\DVLPXOWDQHRXVEOLQNLQJRI
WKHUHGDQGWKHJUHHQ/('$GGLWLRQDOO\WKHGLVSOD\LQGLFDWHVWKDWWKH352/&LVHPSW\UHIHUWR¿JXUH
%Vol.
LC 500
¿JXUH
If you replace the PRO LC, you also have to change the battery PRO B. Otherwise, the correct operation
of the lubricator cannot be guaranteed!
,I\RXUHSODFHWKH352/&E\D352/&RIDGLႇHUHQWVL]HDFRUUHVSRQGLQJSURWHFWLRQFRYHUUHIHUWR
”Accessories and Spare Parts”) must be used.
Since the drive unit and the control board must be protected against moisture, an exchange may only be
carried out in dry conditions!
$IWHUWKHLQVWDOODWLRQRIWKHQHZ352/&WKHFRQWUROV\VWHPFRQWLQXHVWRRSHUDWHXVLQJWKHSUHYLRXVO\YDOLG
VHWWLQJRIWKHGLVFKDUJHSHULRG
6.1 Setting the Volume of the PRO LC
7KHVL]HRIWKH352/&PXVWEHVHWLQWKHFRQ¿JXUDWLRQPHQXZLWKWKHWZREXWWRQVRQWKHGULYHXQLWVHH
¿JXUH3OHDVHDOVRUHIHUWRWKHRSHUDWLQJFKDUWFKDUWFKDSWHU
ATTENTION!
If the displayed setting does not correspond with the attached PRO LC size it will result in incorrect
discharge amounts and wrong signals in the display (Display, LEDs).
Config.
LC250
Config.
LC 500
or
¿JXUH
ATTENTION!
:KHQHYHUD352/&LVUHPRYHGIURPWKHOXEULFDWRUDQGLVUHSODFHGE\DQRWKHU352/&WKHFRQWUROV\VWHP
DVVXPHVWKDWDQHZFRPSOHWHO\¿OOHG352/&ZDVDWWDFKHG
Therefore NEVER attach a PRO LC that is not completely full!