Permobil K - Page 100

Owner’s Manual Permobil K/C300 Troubleshooting
101
The wheelchair cannot be Batteries discharged. Charge the batteries.
started.
The cable connection to Insert the cable in the control
the control panel has panel.
come loose.
Main fuse triggered. Contact service
The wheelchair cannot be Battery charger connected. Stop charging and disconnect
driven. the charging cable from the
wheelchair’s charging socket.
Brake release activated. Reset the brake release.
The wheelchair is locked. Unlock the wheelchair.
See page 34 (VR2),
Pages 64-65 (R-net).
The battery voltage indicator Electronics fault. See page 94 (VR2)
on the control panel is Page 96 (R-net).
flashing fast and the Or contact service.
wheelchair cannot be driven.
The wheelchair stops while The cable connection to Reconnecet the cable between
being driven. the control panel has the control panel and the
come loose. power module.
The wheelchair can only be Seat lift raised too high. Lower the seat lift.
driven at reduced speed.
The wheelchair cannot be Main fuse blown. Replace main fuse. See the
charged. service manual.
The wheelchair “switches The electronics’ Switch the wheelchair on again
itself off” after a certain energy-saving mode has using the start key on the
period of inactivity. been activated. control panel.
EVENT POSSIBLE CAUSE REMEDY
Troubleshooting guide
The following troubleshooting guide describes a number of faults and events
which may occur when you use your wheelchair, together with suggested rem-
edies. Note that this guide cannot describe all the problems and events which
may occur and you should always contact your service provider or Permobil in
case of doubt.