Owner’s Manual Permobil K/C300 Design and function (VR2)
30
Charger
Plug
Single Pin
to bottom
Charging/Programming socket
This socket is used only to charge the wheelchair. A VR2 compatible Hand-held
or PC Programmer can be connected to this socket, in order to make changes to
the wheelchair’s driving characteristics. The socket must not be used as a power
source for any other electrical equipment. Connecting other electrical equipment
may damage the control system or lead to the wheelchair having reduced elec-
tromagnetic compatibility (EMC).
The wheelchair’s warranty ceases to apply if any equipment other than the battery charger belonging
to the wheelchair, the key used for locking, or a compatible programmer is connected to the
control panel’s charging contact.
Charging socket
The charging
contact’s “guide
boss” must face
upwards when it is
to be connected.
Charging
contact
m
WARNING
To Next Page
Loading...
