Owner’s Manual Permobil K/C300 Design and function (VR2)
35
Locking/unlocking the wheelchair
To avoid the wheelchair being used by unauthorized persons, the electronics
unit can be locked by performing the following steps using the On/Off key and
the joystick on the control panel:
Locking:
• Ensure that the wheelchair is switched on. Press and hold down the On/Off
key for approximately 1 second until a signal sounds and then release the
key.
• Move the joystick forwards until a signal sounds. Then move it backwards
until another signal sounds.
• Release the joystick. A longer signal sounds and the wheelchair is now
locked.
Unlocking:
• Switch on the chair with the On/Off key (the LEDs in the speed indicator will
scroll forwards and backwards).
• Move the joystick forwards until a signal sounds. Then move it backwards
until another signal sounds.
• Release the joystick. A longer signal sounds and the wheelchair is now
unlocked.
m CAUTION
Automatic switch-off.
The control system can be programmed so that it is switched off automatically if the wheelchair is
not driven within a specific time. This time is normally set as 30 minutes.