R-Net control panel LCD monochrome display
Function Buttons
On the control panel there are a total of 10 Function Buttons.
On/Off Button
The On/Off button applies power to the control system electronics, wich in turn
supply power to the wheelchair’s motors.
Horn Button
The horn will sound while this button is depressed.
Maximum Speed Buttons
These buttons decreases/increases the wheelchairs maximum speed.
Depending on the way the control system has been programmed a momentary
screen may be displayed when these buttons are pressed.
m
WARNING
Do not use the On/Off Button to stop the wheelchair unless there is an emergency.
If you do, you may get thrown out of the chair or shorten the life of the wheelchair drive components.
On/Off
Speedbuttons, Decrease/
Increase
Mode
Hazard Button & LED*)
Left Indicator Button & LED.*)
Horn Button
Profile Button
Lights Button & LED*)
Right Indicator Button & LED.*)
*) Only active if the wheelchair is equipped with lights.
To Next Page
Loading...
