Permobil K - Page 63

Permobil K/C300 Owner’s Manual
64
Design and function, R-net
Joystick Error - VR2 electronics
If the joystick is moved away from and held away from the central position
shortly before, during and immediately after the wheelchair is started, the battery
voltage indicator’s LEDs will scroll forwards and back and the wheelchair cannot
be driven. To be able to drive the wheelchair again, you must return the joystick
to its central position within 5 seconds.
If this is not done within this time interval, switch the wheelchair off and on again
with the start key on the control panel.
If the wheelchair still cannot be driven after the restart and the battery voltage
indicator’s LEDs are flashing fast, an error has occurred in the wheelchair’s
electronics. See more under the section “Troubleshooting” on pages 94-95, 100.
”Moving” LEDs