PART 8: MAINTENANCE AND SERVICE
PB1319 (CAT. NO. 5296 ) —118— 22-01691 (R02/02)
Fuller Transmission Lubrication
Fuller transmissions are designed so that the internal parts operate in
a bath of oil circulated by the motion of gears and shafts. Grey iron
parts have built-in channels where needed to help lubricate bearings
and shafts. All parts will be amply lubricated if these procedures are
closely followed:
1. Maintain oil level; check it regularly.
2. Change oil regularly.
3. Use the correct grade and type of oil.
4. Buy oil from a reputable dealer.
Lubrication Change and Inspection
Highway Use
• Refer to the Eaton Fuller transmission manual for servicing infor-
mation.
• Refer to the oil change vs. temperature chart below for special oil
change information. The “intermittent peak temperature” is the
maximum temperature observed for a short time in a fully loaded
vehicle performing normally.
Off-Highway Use
• Refer to the Eaton Fuller transmission manual for servicing infor-
mation.
02944
To Next Page
Loading...
