PART 4: CONTROLS AND DISPLAYS
PB1319 (CAT. NO. 5296 ) —36— 22-01691 (R02/02)
For More Efficient Heating and Cooling...
• For immediate heating of a cold cab, operate the heating system
with the “Fresh/Recirc” switch in the “Recirc” position. Switch to
the “Fresh” position when the cab has reached a comfortable tem-
perature.
• For immediate cooling of a hot cab, initially open a cab window.
For maximum summertime cooling, both heater control valves on
the engine should be shut (if so equipped).
• For both heating & cooling, use lower blower speeds and interme-
diate temperature selector positions to modulate cab temperature.
Cigarette Lighter
To operate your lighter, push the knob in. After a few moments the
lighter will automatically pop out, ready to use. After use, insert the
knob, but don’t push it in. The lighter circuit is protected by a 20-
ampere fuse to prevent damage should the lighter get stuck in the IN
position. If this fuse needs replacement, check to ensure that the
lighter is not stuck before replacing the fuse.
The lighter receptacle may be used to power auxiliary equipment that
does not draw more than 20 amperes maximum.
Ashtray
WARNING! Do not exceed the voltage/amperage capacity
of the cigarette lighter. It could result in a fire. Follow all
warnings and instructions in the operator’s manual for the
appliance you are using.
WARNING! Paper or other combustible substances in
an ashtray could cause a fire. Keep all burnable materi-
als besides smoking materials out of the ashtray
02912
To Next Page
Loading...
