PART 5: SEAT AND RESTRAINT SYSTEMS
PB1319 (CAT. NO. 5296 ) —57— 22-01691 (R02/02)
proper guide for your type of seat, and follow the instructions very
closely. It is vitally important that all components must be remounted
back in the same position as the original components that were
removed. This will maintain the design integrity of the mounting
points for the seat belt assembly.
Once the need for replacement of the seat belt has been determined,
be certain that it is only replaced with the recommended replacement
seat belt. The occupant restraint system has been developed and
tested specifically for this vehicle. If the vehicle was originally
equipped with a lap belt, it cannot be replaced with a three-point
shoulder harness system, because the cab mounting points are not
structurally designed for a three-point seat belt.
To Next Page
Loading...
