5. Install the soaked filter.
4. Install the water tray and fasten the snap lids.
Note: Pass the water pipe through the hole of the
water tray, and the snap lids of the water tray need to
be fastened, otherwise it will loosen.
2. Insert the foam filter into the groove of the water
pump. Position the pump according to the bottom slot
shape.
Note: Please pay attention to aligning the recessed
part of the pump with the protruding part of the water
tank, otherwise the pump cannot be installed firmly.
HOW TO USE
1. Soak the filter in a clean bowl for 5 minutes, then rinse
the filter thoroughly with tap water.
Notes:
1)The filter must be fully soaked before the fountain is
turned on; otherwise, the water may not flow through
the filter smoothly and cause spillage.
2)Do not soak the filter in the water tank of the
fountain in case of any surface dust.
3. Install the silicone pipe on the pump. Add water to the
tank.
07 08
Note: Use the small handle to install the filter and keep
this small handle on the outside for easy replacement
in the future. Please make sure the hole of the water
pipe passes through the hole of the filter.
To Next Page
Loading...
