1. Press pump unit firmly in area
marked “Pump”. Suction cups will
align with round recesses along
base of bowl. Suction cups must
grip the bottom of bowl.
2. Route in recess channel behind cord
locator channel (See arrow).
4. Place slide on top of filter reservoir.
Align slide with grooves along back
and middle of bowl. Gently press
to engage locking device. Slide
should go in place easily and fit
securely with no large gaps. Fill
bowl to fill line visible in rear corner.
NOTE: Cord will hang out rear
slide cutout.
3. Place filter reservoir with filter installed
directly in front of pump. Tabs will help
guide filter reservoir positioning for
proper alignment.
5. Insert pump connector cord into AC
adapter. Plug into electrical socket.
NOTE: Pump may take two to three
minutes before it begins circulating
water down the slide. If it does not, un-
plug in-line connector and re-connect.
1
2
4
3
5
Overhead
View
missing
Side View. Filter reservoir.
Filter reservoir will rest
behind alignment wall.
BEFORE PROCEEDING: MAKE SURE PUMP
INTAKE COVER IS SNAPPED ON SECURELY
To Previous Page
Loading...
