A collar worn for too long or made too tight on the pet’s neck may cause skin damage ranging from redness to
pressure ulcers. This condition is commonly known as bed sores.
Avoid leaving the collar on the dog for more than 12 hours per day.
When possible reposition the collar on the pet’s neck every 1 to 2 hours.
Regularly recheck the fit to prevent excessive pressure; follow the instructions in this quick start guide.
You may need to trim the hair in the area of the contact points. However, never shave the dog’s neck; this may
lead to a rash or infection.
Never connect a leash to a collar with contact points. It will cause excessive pressure on the contact points.
When connecting a leash to a separate collar, do not allow it to put pressure on the training collar.
Wash the dog’s neck area and the contacts of the collar weekly with a damp cloth.
Examine the contact area daily for signs of a rash or a sore.
If a rash or sore is found, discontinue use of the collar until the skin has healed.
If the condition persists beyond 48 hours, see your veterinarian.
For additional information on bed sores and pressure necrosis, please visit our website. This product is only for
use with healthy pets. If you’re not certain that your pet is in good health, we recommend that you take your pet
to a veterinarian before using this product.
Charge the Training Collar and Remote
Excessive charging can shorten battery life. Only charge your remote or collar when the batteries are low.
1. Plug in and fully charge the remote and receiver collar. This can take up to 5 hours.
2. When fully charged, the green LED on the collar will turn off, and the battery meter on the remote will stop
cycling and appear full.
3. When the collar and remote are charged, replace their rubber covers.
To Turn the Training Collar On
1. Press and hold the on/off button until you hear a low to high beep and the green LED appears, and then
release.
NOTE: The handheld remote is always on, and the display will appear when any button is pressed.
To Turn the Training Collar Off
1. Press and hold the on/off button until the collar beeps high to low, and then release. The red LED will be
illuminated during the button press and will turn off when the collar turns off.
To Next Page
Loading...
