3. Press either of the top 2 stimulation buttons. The collar LED will blink 5 times to indicate successful pairing.
Lock/Unlock
1. To unlock press and hold the side up/down level adjuster simultaneously for 3 seconds.
2. To lock press and hold the side up/down level adjuster simultaneously for 3 seconds.
Fit the Training Collar
Important: The proper fit and placement of your training collar is important for effective operation. The
contact points must have direct contact with your dog’s skin on the underside of his neck.
1. Start with the collar turned off and your dog standing comfortably, not sitting (A).
2. Place the collar on your pet so that the PetSafe® logo is right side up and the collar is directly under your dog’s
chin. Center the contact points underneath your dog’s neck, touching the skin (B).
NOTE: It is sometimes necessary to trim the hair around the contact points to make sure that contact is
consistent.
3. Check the tightness of the collar by inserting one finger between the end of a contact point and your dog’s neck
(C). The fit should be snug but not constricting.
4. Allow your dog to wear the collar for several minutes, then recheck the fit. Check the fit again as your dog
becomes more comfortable with the collar.
Do not shave the pet’s neck as this may increase the risk of skin irritation. The collar should
To Next Page
Loading...
