Petsafe Indoor Bark Control - Setup and Usage Guidance; Key Definitions; Setup Instructions

4 1-800-732-2677
Key Defi nitions
Microphone: Detects barking up to 25 feet away.
LED: Lights whenever Indoor Bark Control is activated. Also blinks to
show low battery status.
Speaker: Produces the ultrasonic sound.
Button: Manual control activates an ultrasonic tone on demand
Battery Door: Used to enclose the 9v battery
Keyholes: Provision for wall mounting
Battery Door
Keyholes
Microphone
LED
Speaker
__________________________________________
Setup
The PetSafe
®
Indoor Bark Control should be placed facing the dog,
within a range not to exceed 25 feet. For best results, the area between the
Indoor Bark Control and the dog should be free of any large obstacles.
__________________________________________
To Insert and Remove the Battery
1. The PetSafe Indoor Bark Control requires a 9-volt battery (not
included).
2. The battery door is located on the back of the unit. Pull the battery
door open.
3. Install the 9-volt battery with the positive side oriented as shown.
4. Replace the battery door by positioning the top edge, and snap the
bottom of battery door into place.