Need help?Do you have a question about the PEUGEOT XP6 50 and is the answer not in the manual?
Manufacturer recommendations for fluids and parts.
General tips for good repair practices.
Overview of motorcycle specifications and data.
Steps to take apart motorcycle components.
Procedures for putting motorcycle parts together.
Instructions for swapping out worn parts.
Details on operating and adjusting motorcycle systems.
Procedures for fine-tuning motorcycle settings.
Information on the ignition and electrical systems.
Detailed specifications for the motorcycle's engine.
Information regarding the clutch system.
Details about the motorcycle's gearbox and gear ratios.
Specifications for the motorcycle's chassis and frame.
Information on the motorcycle's frame structure and geometry.
Details concerning the motorcycle's steering mechanism.
Specifications for the front suspension system.
Details on the motorcycle's rear suspension setup.
Details on fuel type, tank size, and reserve.
Lubrication requirements for specific components.
Specifications for gearbox lubrication.
Information on coolant type and capacity.
Type of brake fluid required.
Type of oil for the hydraulic front fork.
List of specialized tools for engine work.
List of specialized tools for chassis work.
Recommended maintenance schedule for regular use.
Extended maintenance schedule for demanding use.
Steps to reassemble the clutch cover.
Procedures for taking apart the clutch assembly.
Steps to remove the cylinder head.
Procedures for removing the cylinder.
Steps for removing the piston from the cylinder.
Procedures for removing the exhaust pinion.
Steps to disassemble the selector shaft.
Procedures for taking apart the gearbox.
Steps to disassemble the camshaft.
Procedures for disassembling the crankshaft.
Points to verify before assembling the gearbox and selector.
Steps for assembling the gearbox components.
Procedures for checking the crankshaft alignment and play.
Steps for installing the crankshaft into the right case.
Procedures for checking piston, segments, and cylinder condition.
Steps for assembling the piston and cylinder.
Steps for assembling the crankshaft tight joint.
Procedures for installing crankshaft and camshaft pinions.
Inspection of clutch components for wear and damage.
Detailed instructions for assembling the clutch.
Steps to take apart the water pump.
Procedures for reassembling the water pump.
Steps to replace the oil pump.
Procedures for adjusting the oil pump.
Steps to install the magneto stator base.
Procedures for installing the magneto rotor.
Explanation of the CDI ignition system's operation.
Power source, regulation, and main circuit functions.
How the lighting system functions and is controlled.
Explanation of the turn signal indicators and their wiring.
Operation of neutral, oil level, and temperature indicators.
How the horn is activated and vehicle electrical sockets.
How the indicator station and wiring operate.
To Next Page
General
