Set-up and Initial Commissioning
26
1
2
8.04 Initial start-up
Remove the plug 1 of the oil reservoir 2
before the initial commissioning.
Danger of machine damage!
The plug 1 serves solely for tran-
sit support and may not be used
during the sewing operations.
Inspect the machine, particularly the
electric cables, for any damage.
Clean the machine thoroughly and then
oil it, see also Chapter 10 Maintenance
and Care.
Connect the machine to the compressed
air system. The manometer must show
a pressure of 6 bar. Set this value if re-
quired (see Chapter 10.07 Checking /
setting the air pressure.
Arrange for technical staff to check whether the machine’s motor may be operated at the
existing mains voltage and whether it is connected properly.
Never operate the machine if there are any differences.
The machine must only be connected to a grounded socket!
Arrange for the home position of the machine drive to be verifi ed by certifi ed
technicians before the initial start-up! Have these settings carried out where re-
quired (see the drive service manual in Chapter 4.4.
Fig. 8 - 11
8.05 Switching the machine on / off
Switch the machine on (see Chapter 7.01 Main switch).
8.06 Machine drive home position
See Chapter 4.4 of the drive service manual
To Next Page
Loading...
Need help?
General
