What to do if the needle thread bunches up at the beginning of the seam on my Pfaff Sewing Machine?
If the needle thread bunches up on the wrong side of the fabric at the beginning of the seam, it may be due to a skipped stitch before thread cutting. To resolve this, try the following: * Reset the needle at the proper angle. * Reduce the check spring stroke. * Adjust the needle to hook timing.
What to do if the tail of the needle thread appears on the right side of the fabric with my Pfaff hobby GrandQuilter 1200 Sewing Machine?
If the tail of the needle thread appears on the right side of the fabric, it's likely that a tail of the needle thread that is too long is left after thread cutting. You should adjust the needle to cutter cam timing and adjust the position of the fixed cutter knife.
What to do if the bobbin thread is not cut on my Pfaff hobby GrandQuilter 1200?
If the bobbin thread is not being cut, the fixed cutter knife might be out of position. You should adjust the position of the fixed cutter knife.
Why is the needle thread not cut on my Pfaff hobby GrandQuilter 1200 Sewing Machine?
If the needle thread is not being cut, it could be due to the following reasons: * The fixed cutter is dull: Replace or grind the fixed cutter knife. * The fixed cutter knife is out of position: Adjust the position of the fixed cutter knife.
What to do if skipped stitches occur at the beginning of the seam due to a too short tail of the thread after thread cutting when using my Pfaff Sewing Machine?
If you're experiencing skipped stitches at the beginning of the seam because the thread tail is too short after cutting, the needle to cutter cam timing might be too late. Adjust the needle to cutter cam timing to resolve this issue.
What to do if the fixed cutter knife is out of position on my Pfaff hobby GrandQuilter 1200?
If the fixed cutter knife is out of position, adjust the position of the fixed cutter knife.
What to do if the thread drawing lever is out of position on my Pfaff hobby GrandQuilter 1200?
If the thread drawing lever is out of position, adjust the thread drawing lever position.
What to do if the thread slips out the needle eye when starting sewing with my Pfaff Sewing Machine?
If the thread slips out of the needle eye when starting to sew, it is possible that the proper hook is not used. Use the proper hook.
What to do if the pre-tension is too loose on my Pfaff hobby GrandQuilter 1200 Sewing Machine?
If the pre-tension is too loose, you should tighten the pre-tension.
General| Type | Quilting Machine |
|---|---|
| Stitch Length | Up to 5 mm |
| Stitch Options | Straight stitch |
| Built-in Stitches | 1 |
| Needle System | 130/705 H |
| Free Arm | Yes |
| LCD Screen | No |
| Speed Control | Foot pedal |
| Stitch Speed | 1500 stitches per minute |
Steps to remove and replace the face plate.
Steps to remove and replace the top cover.
Instructions for removing and replacing the belt cover.
Instructions for removing and replacing the motor cover.
Instructions for removing and replacing the machine base.
Steps to remove and install the needle threader.
Adjusting the sideways position of the threader hook for proper alignment.
Adjusting the vertical position of the threader hook.
Setting the pre-tension dial to the correct position relative to the dial face.
Identifies the locations of various electronic components within the machine.
Identifies the locations of electrical connectors on the circuit boards.
Instructions for replacing circuit board F and slide volume.
Instructions for replacing the light bulb inside the face plate.
Instructions for removing and replacing the transformer.
Instructions for replacing the machine socket.
To Next Page
