(A)
(B)
(C)
(D)
(D)
(E)
(G)
(H)
104 72 63-26 31
Replace the Circuit Board-A
To remove:
• Remove the top cover.
• Pull out connectors from the circuit board-A.
• Remove the cords from the cord clips (A).
• Remove the setscrews (B) and the board-A case lid (C)
• Pull out the connectors under the case lid.
• Remove setscrews (D) and circuit board-A.
To attach:
• Install the circuit board-A and secure it with the setscrews (D).
• Insert the following connectors:
(E) Machine socket (primary)
(G) Power transformer (primary)
(H) Driving motor
• Attach the board-A case lid (C) and secure it with the setscrews (B)
• Insert the remaining connectors and secure the cords with the cord clips (A) on the case lid.
.• Attach the top cover.
NOTE: Do not disconnect the connectors by pulling on cord.
To disconnect, grasp the connector, not the cord.
To Next Page
Loading...
