Pfaff hobby GrandQuilter 1200 - Thread Guide Plate Replacement and Adjustment

(A)
(B)
(C)
(E)
(D)
1.4 mm
2.7 mm
20 104 72 63-26
Replace and Adjust the Thread Guide Plate
Requirement
The left inner edge (C) of the thread guide plate should be approximately 1.4 mm from the center of the needle
drop position (D) and the back inner edge (E) of the thread guide plate should be approximately
2.7 mm from the center of the needle drop position (D).
Adjustment
• Remove the needle plate.
• Loosen the fl at screw (A) and adjust the position of the thread guide plate (B).
• The left inner edge (C) of the thread guide plate should be approximately 1.4 mm from the center of the needle
drop position (D) and the back inner edge (E) of the thread guide plate should be approximately
2.7 mm from the center of the needle drop position (D).
• Tighten the fl at screw fi rmly.
• Attach the needle plate.