Pfaff hobby GrandQuilter 1200 - Replacing External Parts: Belt Cover, Motor Cover, and Base; Belt Cover; Motor Cover; Base

(A)
(B)
(D)
(C)
(A)
(C)
(F)
(D)
(E)
(A)
(A)
(A)
(A)
(B)
(C)
(D)
(E)
104 72 63-26 5
Belt Cover
• Remove the 3 setscrews (4 x 12) (C) and remove the belt cover (D).
Pull out the socket connector from the printed circuit board UD connector .
NOTE: When attaching the belt cover, engage the hooks with the motor cover.
Motor Cover
• Remove the Belt cover (D) fi rst
• Remove the 3 setscrews (4 x 12) (A) and remove the motor cover.
Base
Remove the 4 hinge screws (A), washers (B), rubber feet (C) and base washers (D).
Remove the base (E)
To attach, follow the above procedures in reverse.