104 72 63-26 3
Foreword
The purpose of this service manual is to assist you in quick and correct repairing of the machines.
Adjustments should only be made if the settings deviate from the requirements described herein.
When checking or adjusting a machine, always proceed in the order of the work steps prescribed.
For easier reference every work step is marked with a dot.
When assembling dismantled machines, adjust the machine to approximately the right settings.
This facilitates the subsequent fi ne adjustments.
Unless otherwise specifi ed, the hand wheel must always be turned forward.
When carrying out maintenance work on live parts or in their proximity, the machine is to be separated
from the power supply by unplugging the lead cord from the electrical socket.
For the proper adjustment of the machine, the following gauges and tools are required:
1,5 mm Allen key 07-433 005-28/000
2 mm Allen key 07-433 005-30/000
2.5 mm Allen key 07-433 005-40/000
Phillips Size 0 - small 07-434 001-15/000
Phillips Size 1 - medium 07-434 001-18/000
Phillips Size 2 - big 07-434 001-20/000
Subject to alterations in design and dimensions.
To Next Page
Loading...
