(A)
(B)
(C)
(A)
(A)
(B)
(C)
(D)
(E)
(F)
(G)
(F)
(H)
(I)
(J)
32 104 72 63-26
Replace the Light Bulb
Light bulb inside of the face plate
• Remove the face plate (A).
• Pull out the light bulb (B) from the lamp socket (C).
• Insert a new bulb and push it into the lamp socket.
• Attach the face plate.
Replace the Circuit Board-F and Slide Volume
1. Removed the top cover and the belt cover.
2. Pull out the circuit board-F connector (B) , slide volume connector (C) and the thread cuttet switch
connector (D) from the circuit board-A .
3. Loosen the 2 set screw (A). Remove the ornamental panel .
4 . Remove the 2 set screws (G) and remove the circuit board-F (H) from the panel.
5. Remove the 2 CS-rings (I) and slide volume (J) .
To attach: follow the above procedure in reverse.
To Next Page
Loading...
