Pfaff hobby GrandQuilter 1200 - Feed Dog Height Adjustment

0.8–1.0 mm
(A)
(X)
(Y)
(C)
(E)
(D)
104 72 63-26 15
Adjustment of the feed dog height
Requirement
When the feed dog is in it’s highest position. The Feed dog teeth top (E) should be 0.8 to 1.0 mm from the
surface of the needle plate (D).
Check
• Select the machines longest stitch lengths setting.
• Turn the hand wheel until the feed dog (D) comes to its highest position.
• The Feed dog teeth top (E) should be 0.8 to 1.0 mm from the surface of the needle plate (D).
Adjustment
• Select the machines longest stitch lengths setting.
• Turn the hand wheel until the feed dog (D) comes to its highest position.
• Loosen the screw (A)
• Turn the eccentric pin (C) so that the feed dog height becomes between 0.8 mm to 1.0 mm from the surface
of the needle plate (D).
- (X) To raise
- (Y) To lower
• Tighten the screw (A).