Installation and commissioning
8 - 5
8.02 Commissioning
● Check the machine, particularly the electrical wiring, for any damage.
● Clean the machine thoroughly and then oil it or fill in oil (see Chapter 10 Care and
maintenance).
● Have a mechanic check whether the motor of the machine can be operated with the
available power supply, and that the motor is correctly connected in the junction box. If
there are any discrepancies the machine must not be operated under any
circumstances.
The machine may only be connected to an earthed socket!
● When the machine is running, the balance wheel must turn towards the operator. If it does
not, have the motor connection changed by a mechanic.
● Machines with pneumatic equipment must be connected to the compressed air supply.
The pressure gauge should indicate a pressure of 6 bar. If necessary, adjust to the correct
setting (see Chapter 10.05 Checking adjusting the air pressure).
8.03 Switching the machine on/off
● Switch the machine on or off (see Chapter 7.01 On/off switch).
To Next Page
Loading...
Need help?
General
