A
B
C
D
SEWING – 33
Securing the Thread Chain
Tie a Knot (A)
To avoid the thread chain from ravelling, separate and
tie the thread ends together.
Use a Sewing Needle (B)
1. Thread the chain into a large eyed, hand sewing
needle.
2. Insert the needle into the end of the seam and pull
the chain into the seam to secure the threads.
Cutting the Seams Open
Cut the upper looper thread with a seam ripper (not in-
cluded with the machine) to cut the seams.
Use the Machine at the End of a Seam (D)
1. Serge one stitch off the end of the seam.
2. Raise the needle and presser foot, and gently pull
the threads off the stitch nger.
3. Turn the fabric over so that the under side is up.
4. Serge approximately 1˝ (2.5cm) over the stitching
and angle off the fabric.
Use the Machine at the Start of a Seam (C)
1. Before placing the fabric in the machine, sew a
thread chain approximately 2″-3″ (5-8cm) long.
2. Place your fabric in front of the presser foot. Sew a
few stitches and stop.
3. Raise the presser foot and bring the thread chain to
the left around and under the presser foot.
4. Place the thread chain between the presser foot and
upper knife, holding it in position as you lower the
presser foot to sew.
5. After sewing approximately 1˝ (2.5 cm), move the
chain to the right and under the upper knife, cut-
ting the chain as you sew.
To Next Page
Loading...
