6
Introduction
Important: Make sure that the IDT™ system is disengaged when using presser foot 2A, 5B.
Presser feet
Standard presser foot 0A with IDT™ system (shown as in the display,
attached on the machine upon delivery)
This foot is used mainly for straight stitching and zigzag stitching with a stitch
length longer than 1.0 mm.
Fancy stitch foot 1A with IDT™ system (shown as in the display)
This foot is used for decorative stitches. The groove on the underside of the foot
is designed to fl ow smoothly over the stitches.
Fancy stitch foot 2A (shown as in the display)
When sewing decorative stitches or short zigzag stitches and other utility
stitches with less than 1.0mm stitch length, use this foot. The groove on the
underside of the foot is designed to fl ow smoothly over the stitches.
Blindhem foot 3 with IDT™ system
This foot is used for blindhem stitches. The toe on the foot guides the fabric. The
red guide on the foot is designed to ride along the fold of the hem edge.
Zipper foot 4 with IDT™ system
This foot can be snapped on either the right or the left of the needle, making it
easy to sew close to both sides of the zipper teeth. Move the needle position to
the right or left to sew closer to zipper teeth.
One step Buttonhole foot 5B (shown as in the display)
This foot has a space in the back to set the size of the buttonhole. The machine
will sew a buttonhole to fi t that button size.
To Next Page
Loading...
Need help?
General
