Pfaff creative sensation pro II - Page 144

9:14
Embroidery mode - stitch-out
'\QDPLFVSULQJIRRW'LVUHFRPPHQGHG
For regular embroidery it is always recommended
to use the Dynamic spring foot 6D for best result.
If you have deselected Dynamic spring foot 6D
for embroidery in the Settings menu, the machine
displays a pop-up when switching to Embroidery
stitch-out, allowing you to select Dynamic spring
foot 6D without opening the Settings menu.
If foot 6A is selected, the ActivStitch
™
Technology
feature will automatically select thread tension.
Check needle thread
The machine stops automatically if the needle
thread runs out or breaks. Re-thread the needle
thread, close the pop-up, step back a few stitches
and start embroidering again.
&KDQJHWKUHDGFRORU
When it is time to change the needle thread, the
machine stops and the upper thread is cut. Change
the spool and re-thread the machine. The next
recommended color is shown in the pop-up.
Cut thread end
If Cut jump stitches is not activated in Machine
settings in the Settings menu, the machine will stop
after stitching a few stitches. Cut the thread and
press start/stop to continue embroidering.
(PEURLGHU\LVÀQLVKHG
:KHQWKHHPEURLGHU\LVÀQLVKHGDSRSXSZLOO
appear on the screen. Touch OK to keep the
design(s) loaded and stay in Embroidery stitch-out.