1:9
G
H
F
I
F
Operate your hobby 1132/1122
Threading the machine
Turn off the main switch.
Raise the presser foot and turn the
handwheel towards you until the take-up
lever (F) is in it's highest position.
Pull the thread from the spool and pass it
under the thread guide (G). Then pull it
down along the right threading slot.
Pull the thread up around the bottom of
the thread guide plate (H).
Firmly pull the thread from right to left
over the take-up lever (F) and down into
the take-up lever eye.
Pull the thread down into the left
threading slot and slip the thread behind
the needle bar thread guide (I) from the
left.
Thread the needle from front to back
through the needle eye.
To Next Page
Loading...
Need help?
General
