12
Threading the upper looper (red)
Open the looper cover and the swivel plate.
Place the spool on the second spool pin
from the right. The guide points for the up-
per looper thread are marked in red. Two
threading diagrams are located behind the
looper cover to help you with the threading.
Guide the thread from the rear through the
second thread guide from the right.
Guide the thread through the fourth and the
third hole from the right on the thread guide
plate, as shown in the illustration.
Guide the thread from the right to the left
into the left guide (3).
guide plate
guide (3) for
the upper
looper
thread
thread guides
To Next Page
Loading...
Need help?
General
