26
Using the seam guidelines
On the top side of the looper cover, you will
find seam guidelines which indicate the
distance from the needles. These guidelines
should help you to properly position your
fabric when sewing.
Starting sewing
Lay the sewing material under the front of
the presser foot (it is not necessary to raise
the presser foot). Turn the handwheel ca-
refully a few revolutions towards you and
check the thread chain. Start sewing slowly.
The sewing material is fed automatically.
Guide the sewing material in the desired
direction.
Finishing sewing
When you have completed your seam, allow
the machine to continue to sew slowly until
the thread chain has attained a length of ap-
prox. 12 cm (4 3/4”). At the same time, pull
the thread chain gently towards the rear.
Cut the threads off using the thread cutter,
as shown in the illustration. Leave a thread
chain approx. 5 cm (2”) long beyond the end
of the fabric.
To Next Page
Loading...
Need help?
General
