15
C
Oper at e your Pfaff select
Winding through the needle
Ev en i f the m achi ne has been compl etel y
threaded, you can still wind the bobbin.
Fi r st mak e sur e t o stop the needle f r om
moving while winding the bobbin (see
page 12).
Threading
Raise the presser foot lifter (15). Pass the
needle thread through the presser foot
and then upwards through the right
threading slot (12).
Now, pull the thread into the take-up
lever from left to right (10). The take-up
lever must be positioned at its very top.
Pass the thread to the right under the
hook C. Then wind the thread several
times around the bobbin.
Winding
Sw itch on the main switch (1) and press
the foot control. The winding action will
st op au t om at i cal l y as soon as t he bobbi n
is full. Cut the thread, push the bobbin to
the left and remove it.
Don’t forget:
Turn the handwheel release disk (3)
back again. Then turn the handw heel (4)
towards you until it snaps into place.
To Next Page