Pfannenberg DTS 6201C

Questions and Answers

A
Angela LiuAug 15, 2025
Why is my Pfannenberg DTS 6201C unit not cooling sufficiently?
- R
  Rebecca WilkersonAug 15, 2025
  There are several reasons why your Pfannenberg Accessories unit might not be cooling enough. It could be due to exceeded operating limits, so check the ambient temperature and internal load. Another cause might be too little coolant, in which case you should call authorized qualified personnel and check the unit for leakage. A dirty heat exchanger, a defective evaporator fan (internal) or condenser fan (external) could also be the reason; in these cases, clean the heat exchanger or call authorized qualified personnel to replace the fan. Also, check for any disruption in the air circulation inside the cabinet, the supply and outlet flow of air, and the DIP switch and cable connections.
K
kgonzalezAug 18, 2025
What to do if condensate accumulates in my Pfannenberg Accessories switch cabinet?
- C
  Christopher GonzalezAug 18, 2025
  If condensate is accumulating in your Pfannenberg Accessories switch cabinet, it could be due to a few reasons. The exhaust temperature might be too low, so try closing the cabinet door. Also, the switch cabinet might not be sufficiently sealed, so correct any leaky points or seals. Finally, check the temperature setting.
A
Ashley LutzAug 21, 2025
How to troubleshoot a Pfannenberg DTS 6201C unit that doesn't cool but the evaporator fan is running?
- G
  Gary DicksonAug 21, 2025
  If your Pfannenberg Accessories unit isn't cooling, but the evaporator fan is running, the temperature setting may be too high. Check the temperature setting.
C
Chad BentonAug 25, 2025
Why is condensate draining from my Pfannenberg DTS 6201C Accessories unit?
- T
  Thomas SmallAug 26, 2025
  If condensate is draining from your Pfannenberg Accessories unit, it could be caused by a defective condensate evaporator or too much condensate accumulation. Try replacing the fuses for the condensate evaporator. Also, check if the switch cabinet is sufficiently sealed and correct any leaky points or seals.
M
Michael LeAug 28, 2025
What to do if the condensate does not drain from my Pfannenberg DTS 6201C unit?
- S
  Samantha StevensAug 28, 2025
  If the condensate is not draining from your Pfannenberg Accessories unit, the condensate drain may be plugged up. Clean the condensate drain. Also, check whether the condensate drain hose is free from kinks and is installed with a downward slope.
J
jdennisSep 1, 2025
What to do if condensate accumulates in the switch cabinet of Pfannenberg Accessories?
- Y
  yhamptonSep 1, 2025
  If condensate is accumulating inside the switch cabinet with your Pfannenberg Accessories, the exhaust temperature might be too low; in this case, close the cabinet door. Another potential cause is an insufficiently sealed switch cabinet. Address this by correcting any leaky points or seals. Also, ensure that the temperature setting is correct.
D
Dennis Wilson Jr.Sep 4, 2025
What to do if my Pfannenberg Accessories unit cools only periodically?
- B
  Brandon DelgadoSep 4, 2025
  If your Pfannenberg Accessories unit cools only periodically, the temperature might be set incorrectly. Try setting a higher temperature. If the issue persists, call authorized qualified personnel to check the unit.
C
Casey RodriguezSep 7, 2025
How to fix a Pfannenberg Accessories unit when condensate does not drain?
- T
  tblackSep 7, 2025
  If condensate isn't draining from your Pfannenberg Accessories, start by cleaning the condensate drain, as it may be plugged up. Also, verify that the condensate drain hose is free from kinks and installed with a downward slope.
A
alexander48Sep 12, 2025
What to do if Pfannenberg Accessories unit does not cool but evaporator fan is running?
- C
  Christopher RobinsonSep 12, 2025
  If your Pfannenberg Accessories unit isn't cooling but the evaporator fan is running, check the temperature setting and adjust if it is too high.