Need help?Do you have a question about the Pfeiffer Vacuum OmniStar GSD 300 O1 and is the answer not in the manual?
General| Type | Quadrupole Mass Spectrometer |
|---|---|
| Mass Range | 1 - 300 amu |
| Detectable Gases | All gases and vapors |
| Power Supply | 100 - 240 VAC, 50/60 Hz |
| Applications | Gas analysis, leak detection, process monitoring |
| Ion Source | Open Ion Source |
| Detector Type | Secondary electron multiplier (SEM) |
| Interface | RS-232, Ethernet |
| Operating Temperature | 10 - 35 °C |
| Weight | Approx. 25 kg |
Specifies the product part numbers to which this manual applies.
Defines the primary application scope for the GSD 300 gas analysis system.
Information on available application, operating, and maintenance courses.
Covers technology safety, personnel training, responsibilities, and workplace design.
Details regulations, danger signs, and precautions for handling process gases.
Explains DANGER, CAUTION, and skilled personnel symbols used throughout the manual.
Outlines Pfeiffer Vacuum's responsibility and warranty terms, including user obligations.
Illustrates the unit's external features, ports, and connections.
Describes the function of status indicators and controls for heaters.
Procedures for unpacking, checking for transport damage, and carrying the unit.
Steps for connecting the exhaust gas line and the main power supply.
Instructions for connecting the capillary and communication interfaces.
Steps for removing and mounting equipment covers and final installation checks.
Specifics on connecting the power cable, voltage checks, and grounding.
Guides on turning on the mains switch and waiting for system stabilization.
Configuration steps for the Balzers Quadstar™™ 422 system.
Tuning ion source parameters for OmniStar™™ using test gases.
Tuning ion source parameters for ThermoStar™™ with various test gases and calibration units.
Procedures for switching on, operating heaters, and interacting with software.
Steps for safely powering off the unit and preparing it for transportation.
Lists admissible temperatures, humidity, gas flow, materials, and power data.
Instructions on how to clean the exterior of the unit safely.
Instructions for shortening the capillary to resolve clogging issues.
Detailed steps for replacing the capillary on OmniStar™™ and ThermoStar™™.
Procedures for replacing the orifice on OmniStar™™ and ThermoStar™™ units.
Guidance on identifying and replacing blown fuses in the unit.
Lists optional accessories and tools for use with the unit.
Details spare parts for the gas inlet system, including capillaries and ferrules.
Procedures for safely dismantling and separating components for disposal.
Form for declaring any hazardous substances the product may have contacted.
Official statement confirming product compliance with EU directives and standards.
To Next Page