Cleaning and maintenance
20 | 26 Operating instructions HE 50 | Revision 7
6 Cleaning and maintenance
NOTICE
Opening the housing and inappropriate operation will invalidate the
warranty.
To ensure trouble-free operation, it is essential for the HE 50 to be
cleaned and maintained at regular intervals.
Cleaning
NOTICE
Do not use any sharp objects or tools for cleaning. Only use objects
that are expressly intended for this purpose.
During
cleaning, make sure that no water, steam or dust can
penetrate the electronics area.
Cleaning and maintenance intervals:
AEM = After each measurement
AR = As required
6.1.1 Measurement cell
Clean the top part of the measurement cell with the hand brush.
When brushing, make sure that the milling disk is pointing downwards,
to prevent any dirt getting into the threads.
AEM
Clean the bottom part of the measurement cell with the hard or soft
brush, depending on the moisture and degree of gumming.
AEM
With very moist, oily and sticky products, it is recommended that you
mill a dry sample of cereal (approx. 14 % moisture content) in the
measurement cell as a cleaning measure.
Residues will be bound up with the meal and can be removed easily.
NOTICE
Do not empty the measurement cell top part or bottom part by
knocking it out!
This can lead to damage to the measurement cell.
To Next Page
Loading...
Need help?
General
