Operation
Revision 7 | Operating instructions HE 50 17 | 26
5.4.1 Moist products
Fill a heaped measurement cup with the moist product (e.g. freshly harvested
maize, approx. 9 g) and distribute the content in the bottom part of the measure-
ment cell.
Screw the measurement cell together, open it, empty and clean it.
Fill the measurement cell again and carry out a measurement.
This procedure increases the measurement accuracy for moist
products.
When changing from a moist product to a very dry product, it is also
recommended that this »dummy test« should be performed.
5.4.2 Oily products
When measuring moist rape seed and moist sunflower seeds, it is possible that the
milling disks might touch one another when being screwed together.
Display shows:
range
Repeat the measurement.
With rape seed, fill a heaped measurement cup, and with sunflower seeds, fill
two measurement cups up to the level of the brim.
The measurement result is not falsified in this case!
5.4.3 Tough products
To fill the measurement cell, use one well filled measurement cup.
Particularly with peas and beans in the tough condition (17 % - 20 % moisture
content), it is recommended that you should only screw the measurement cell
partially together and then open it again.
Repeat this procedure two or three times until the measurement cell can be screwed
together as far as the stop.
5.4.4 Finely grained products
When measuring finely grained products (e.g. meal, semolina, flour and grass seeds) it
is possible for the milling disks to touch one another when being screwed together.
Display shows:
range
To Next Page
Loading...
Need help?
General
