PFISTERER CONNEX cable connector Size 3 and 3/S Safety 7
2. Safety
The product has been manufactured at the time of its development and production
according to accepted engineering standards and is deemed safe to operate.
However, this product may present dangers if not used properly or according to its
intended purpose by professionally trained personnel.
The chapter "Safety" provides an overview of all key safety aspects for optimal personal
protection as well as for the safe and trouble-free operation of the product.
Furthermore, the other chapters of these installation instructions contain specific safety
notes, marked by symbols, to avert danger.
2.1 Intended use
The CONNEX cable connector (inner cone system according to DIN EN 50180/50181) Size 3
and Size 3/S is primarily intended for cable connections according to DIN VDE 0276-620.
Operational safety is only ensured when the product is used as intended.
ATTENTION!
Any use of the product exceeding the intended use and/or any different use is
prohibited and deemed as not in accordance with the intended use.
Any claims against the manufacturer and/or his authorized agents because of
damages resulting from unintended use of the product are excluded.
The operator is solely liable for all damages resulting from unintended use.
The intended use also includes proper compliance with the operating conditions as well as
specifications and directions of these installation instructions.
The product may only be operated together with the parts listed in the scope of delivery.
2.2 Content of the installation instructions
Any person ordered to work on or with the product must have read and understood the
installation instructions prior to begin working with the product. This also applies if the
respective person has already worked with such or a similar product or has been trained
by the manufacturer.
Knowledge of the content of the installation instructions constitutes one of the prerequisites
to protecting persons against dangers and to avoid errors thereby operating the
product in a safe and trouble-free manner.
It is recommended for the operator to request tangible proof by the personnel of having
taken notice of the installation instruction's content.
2.3 Modifications and changes to the product
To avoid dangers and to ensure optimal performance, neither changes nor modifications
and attachments may be made to the product that have not been expressly approved by
the manufacturer.
To Next Page
Loading...
